TELUS finally has something other than their basic high speed internet available in the small town I live in (High Speed Turbo) to which I have signed up for and is being activated tomorrow. I've been trying to figure out how to run their ZyXEL VSG1432 gateway in Bridge mode only so I can use my Cisco E4200 V2 that I already have configured and working on an old TELUS SE567 in bridge mode.
Can anybody point me in the direction of some instructions for running this gateway in bridge mode only? I've found some instructions in the thread at
http://www.dslreports.com/forum/r27826544-Zyxel-VSG1432-B101-Modem but when I get to step 3, I don't have a broadband section under the Network Settings to change the mode to bridge.
All help appreciated.
Mike
↧